Elenco Surface Mount Generator Kit Instrukcja Użytkownika Pobierz pdf (Strona 11)

-10-

! Remove the backing from each rubber foot and

place them in the locations shown in Figure M.

! Assemble the top and bottom case sections and

fasten with four 2.8 x 8mm self-tapping screws as

shown in Figure M. Make sure the slots on the

side line up with one another.

! Turn the shafts on the two potentiometers and

rotary switch fully counter-clockwise. Push the

three knobs onto the shafts so that the line on the

knobs are on the points shown in Figure N.

Figure M

2.8 x 8mm Screws

2.8 x 8mm

Screws

Rubber feet

Rubber

feet

Slot

Figure N

FINAL ASSEMBLY (continued)

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

Brak uwag

Elenco Surface Mount Generator Kit Instrukcja Użytkownika Strona 11